Product #: LTP-15-0-6
This product will only be delivered to Mainland UK
LTP Grout & Tile Protector is a colourless barrier that helps to protect porous wall and floor tiles and grout joints from penetration by water, dirt, oil, grease, limescale and efflorescence; making treated surfaces easier to keep clean. Used as a top coat, this product is an easy way to further protect natural stone and all other types of masonry surface
Key Features
- Protects porous natural stone, masonry and grout joints against water, dirt, grease, mould and limescale
- An easy to apply, quick drying spray-on formula
- Completely dissipates and does not leave any hard to remove residue - dries invisible
- Makes treated surfaces easier to clean
- Ideal for use in wet rooms and shower enclosures
- Suitable for both wall and floor grout and natural stone borders
- Suitable for internal and external use
- Coverage per 600ml:
- 600 linear metres depending upon the size of grout joint and number of coats required
- 5-25m of tile and grout depending upon the porosity and the number of coats required
Instructions for use
Always test the solution on an inconspicuous area before general application
- The surface area to be treated must be fully cleaned and allowed to dry
- Older contaminated and dirty grouting should be cleaned with LTP Grimex and then rinsed thoroughly
- Newly grouted surfaces should be left to cure for 20-30 minutes and should be clean and free from dust before application - Shake LTP Grout & Tile Protector can well, and spray 15-20 cm from the surface in a sweeping motion
Note. Do not spray on to acrylic or stained surfaces such as cabinets and stained timber skirting boards - mask and protect these surfaces before application - Touch dry within 5 minutes
- Allow for a 2-3 hour curing time upon completion before allowing traffic
In wet areas i.e. shower enclosures and wet rooms, allow the sealer to cure for a minimum of 24 hours before use - Test area after application with a little water, if the water is absorbed, a second or even third coat may be required to obtain maximum performance
Note. Stubborn residues left on the surface can be removed with the application of more LTP Grout & Tile Protector, which should then be buffed off immediately
Beware: Use only in open or well-ventilated areas. Open windows and if possible use fans to circulate air. It is recommended that a suitable respiratory mask be worn at all times
Recommendations
It is advisable to use a suitable liquid impregnator such as LTP Mattstone or LTP Colour Intensifier, when sealing a porous stone, before finishing with LTP Grout & Tile Protector.
Do not use harsh abrasive cleaning agents. Clean treated areas with water and a mild PH neutral detergent such as LTP Waxwash. In some instances it may be necessary to use a stronger cleaner, such as LTP Grimex, to remove stubborn surface marks; in which case you may need to re-seal treated areas
